Teeth, Tooth Adapter and Retainer suitable for Bofors B-Lock B2
For Bofors B-Lock B2, the LIS® range includes one excavator tooth, one loader tooth, one tooth adapter and the corresponding retainer. The correct component is identified by the reference number on the existing part, the product type and the geometry of the B2 adapter interface.
- Teeth: excavator tooth 032 102, also 32102, and loader tooth 032 101, also 32101
- Tooth adapter: 032 004, also 32004, for cutting-edge thicknesses from 35 to 50 mm
- Retainer: 032 201, also 32201
📞 +49 (0)2241 26 56 700
Notice: LIS® replacement parts. The Bofors and B-Lock names are used solely to identify compatibility. These are not original parts from the manufacturer.
Search for machines (e.g. Komatsu PC200 LC-7)
Distinguish the B2 excavator tooth from the loader tooth
Two tooth designs are confirmed for Bofors B-Lock B2. The excavator tooth carries reference number 032 102, also 32102. The loader tooth is listed under reference number 032 101, also 32101.
Both teeth belong to size B2 and are used with the confirmed B2 tooth adapter and corresponding retainer. They remain different product types. Sharing the same system size does not make the excavator tooth and loader tooth interchangeable. The reference number, product type and existing adapter interface must match.
Compare tooth adapter 032 004 and retainer 032 201
The tooth adapter 032 004, also 32004, is a weld-on adapter for cutting-edge thicknesses from 35 to 50 mm. Its confirmed approximate dimensions are 205 × 97 mm. The retainer 032 201, also 32201, measures approximately 86 × 35 mm.
These dimensions help when comparing the replacement part with the removed component. They do not replace a check of the adapter and retention geometry. When replacing the tooth adapter, the actual cutting-edge thickness must also fall within the confirmed range.
Check tooth movement and adapter wear
If the tooth has noticeable movement on the adapter, inspect the adapter nose, contact surfaces and retainer area together. A new retainer cannot compensate for a worn or deformed adapter interface.
Before fitting the replacement components, check the tooth adapter and retainer for wear, chipping and deformation. Damaged or deformed retainers should not be reused.
Do not identify B2 from the machine model
B2 identifies a size within the Bofors B-Lock tooth system. It is not a fixed machine or operating-weight class. Machine make, model and operating weight therefore confirm neither the existing B2 adapter nor the required tooth design.
Technical identification is based on the reference number of the removed component, the product type, the adapter interface and the specified retainer. The existing cutting-edge thickness must also be checked when replacing the tooth adapter.
Distinguish B2 from adjacent sizes and PIN-Type
Sizes Bofors B-Lock B1 and Bofors B-Lock B3 use their own size-specific adapter and retention geometries. Similar tooth shapes or adjacent size designations do not confirm interchangeability.
An overview of the available sizes is provided under Bofors B-Lock Tooth System.
The separately listed Bofors PIN-Type Torpedo teeth and roll pins do not belong to the B-Lock B2 system. Components from the two systems must not be treated as interchangeable.
Lifetime breakage guarantee: LIS® cutting tools such as teeth and tooth adapters are covered by a lifetime breakage guarantee. Coverage is limited to material and manufacturing defects and does not include normal wear caused by operating conditions. Further information is available in the LIS® warranty terms.
📞 +49 (0)2241 26 56 700
Notice: LIS® replacement parts. The Bofors and B-Lock names are used solely to identify compatibility. These are not original parts from the manufacturer.